Epson EHT-400c windows 95 blues

[Paisley Pirate]

Hey,

Got the EHT-400c tablet, played with it in win3.11, until I got the hdd for it, (was using a memory card for 3.11) and now have installed windows 95b on it. that took a little doing, but it's there... but now I have 2 issues.

1. I cannot get pen extensions to load. I may be doing something wrong in trying to load it. I can't get it taken as mouse, and tried loading it, and I just can't get it figured out... any ideas????

OK, so I really am not doing well. I took 2 minutes and did the same thing I did earlier, and now Pen Extensions works perfectly.


2. I also cannot get the additional pcmcia card slots to be read. The pcm services on the rom is there, but I don't remember how to get the thing pointed to it to work...


Any ideas or suggestions?

Thanks.

[Terry Yager]

1. Remove the PCMCIA drive from socket #1, then reboot from the flashdrive.

2. After it's fully booted, replace the drive (it's hot-pluggable). It should now be accessable. (On mine, it shows up as drive E:).

3. Now you should be able to copy the files from the flashdrive (C:) to the mechanical drive.

4. Reboot from the hard drive (you may have to do a hard reset).

5. It may be necessary to reinstall Win95 after you make the drivers available for Setup.

6. Lemme know how ya make out.

When I boot my Epson, the PCMCIA sockets show up in MyComputer as 'Removable Drive x:', etc.

--T

[Paisley Pirate]

I've got the PCM3 drawer on the drive with win95 on it. It doesn't see it as a set up file for pcmcia hardware, and it doesn't seem to be loading as a software file.

Where should I put these files, and how should I tell win95 to look at them?

Thanks.

[Terry Yager]

Can't help much right now, my bats are dead, and I can't find me charger. If all else fails, there's always 'Plan B', send me the drive and I'll clone mine onto it. Pm me.

--T